Icemaker stopped making ice.
Kenmore french door bottom freezer not making ice.
Assume they are good at this point.
If your freezer is too warm to keep the ice cream firmly frozen and you see lots of frost inside the entire freezer compartment then warm moist air may be leaking through the refrigerator or.
Check the water lines in the back of the refrigerator to see if there is a visible kink or clog from the hard water that flows from the house line system.
In addition check to see if frost has accumulated on the evaporator coils.
Your freezer may also be too warm to produce ice properly usually because the door has not been closed completely the machine was only plugged in recently or the freezer temperature is set too low.
I have ohmed out coils of water solenoids and they have high resistance and do not read ol.
Defrost system problems dirty condenser coils fan failures leaky door gaskets or control problems can lead to your freezer not getting cold enough.
When you re sure that all the items listed above are not the cause a frozen water line may be the culprit.
If the freezer door hinge has been bent or dented it may cause the door to sag.
If your icemaker is not producing enough ice you could need more ice than your machine is able to produce which is approximately 100 cubes in a day.
A kenmore ice maker that is not filling with water may have a frozen or clogged water line.
Ice maker not making ice.
A drain hole.
You can defrost the line with a hair dryer.
How to fix an iced freezer bottom.
If the freezer temperature is too high ensure that the condenser coils are clear of debris and the condenser fan is working properly.
Seems it is not refilling with water.
By continuing to use this site you consent to the use of cookies on your device as described in our cookie policy unless you have disabled them.
If you locate a frozen line unplug the refrigerator and turn the water supply line off.
I have a kenmore french door side by side with lower drawer freezer.
Kenmore elite french door bottom freezer not making ice or dispensing water answered by a verified appliance technician we use cookies to give you the best possible experience on our website.
Every six to eight hours the defrost timer in your freezer turns on to melt any frost or ice buildup on the cooling coils behind the freezer wall.
I do not get a 115v reading from supply to solenoid coils.
The freezer temperature should be set between 0 and 5 degrees fahrenheit 18 to 15c for the ice maker to work properly.
Adjust or replace the hinges so the door shuts and seals properly.
This moist air may cause excessive frost to form on the drain tube causing it to freeze.
Always keep the hair dryer above the water source to avoid electrical shock.